automatic switch position

According to the operating logics of 110 kV automatic stand-by power switching devices,this paper analyzes the problems as to the introduction of the breaker condition contact and the cooperation with the security and stability system.

根據備用電源自動投入裝置的動作邏輯,對110kV備用電源自動投入裝置開關位置接點的引入問題和與安全穩定系統的配合問題進行分析,并結合電網的實際情況,探討具體的解決方案,目的是進一步提高110kV備用電源自動投入裝置動作的準確性。

Drain Plug/Backup Light Switch Location

放油塞/倒車燈開關位置

a switch in the up position.

位于上升位置的開關

DISCONNECT THE PARK NEUTRAL SWITCH.

斷開停車空檔位置開關。＊＊

holding position

(繼電器 的)吸持位置；自保位置；保持(開或關的)位置

TRACTION CONTROL SWITCH (TC) LOCATION

牽引控制開關（ＴＣ）位置

Three-position switch (120 deg. step). Contact positions can be specified.

位置開關（120 度間距）?？芍付ㄓ|點位置。

TURN IGNITION FROM THE OFF POSITION TO THE ON (RUN) POSITION.

把點火開關由關閉位置轉到打開（運行）位置。

Park/Neutral Position Switch and PRNDL Switch

停車／空檔位置開關及ＰＲＮＤＬ開關

Be sure to turn off the switch before recharging.

務必在充電前將電源開關置于OFF位置

Make sure switch is OFF before turning on power.

接通電源前,應確保開關處于斷開位置。

To release from a closed or fastened position.

打開從關閉的或固定的位置上移開

Initial Position Estimation of Sensorless Switched Reluctance Motor

無位置傳感器開關磁阻電機初始位置檢測方法

T3Manual Valve Lever Position Switch C3 Sense or Park/Neutral Position Switch Sense circuit.

＊＊Ｔ３＝手工閥門操縱桿位置開關Ｃ３感知或停車／空檔位置開關感知電路

PRESS THE DOOR LOCK SWITCH TO THE LOCK POSITION.

把門鎖開關壓到鎖的位置。

Set the TAPE/OSC switch to the correct position.

將TAPE/OSC開關設定于正確的位置

TRS connector or P/N position switch connector

ＴＲＳ接頭或Ｐ／Ｎ位置開關接頭

NOTE: THIS IS NOT THE PARK NEUTRAL POSITION SWITCH.

注意：這不是?？諜n位置開關。

TRANSMISSION SWITCH AND PLUG LOCATIONS

變速箱開關與注油塞位置